How To Tap A Keg At Home

Pack more ice in the garbage bag around the perimeter of the keg.

How to tap a keg at home. While applying downward pressure turn the tap system clockwise as far as it will go about 90 degrees. Line your keg bucket with a plastic garbage bag. When youre ready to imbibe open the carbon dioxide tank and adjust the pressure start with 12 psi then attach the keg via the coupler. To secure the tank connection pull the tap handle out away from the keg coupler 10 and push down until it locks into position.

With the pump handle up this is the off position line up the coupler lugs with the corresponding openings on the keg valve. How to install a beer tap at home. Line the notches up with the hole at the top of the keg. Wet the o ring on the top with water so it will provide a good seal and then pop the top on your keg.

Listen for the click of the pull handle when it shifts into the final downward position and your keg will be tapped. Place your keg in the bag and on top of the ice. The slits guide the taps notches and hold the tap in place. Get your tap making sure it is not engaged this will give you a beer shampoo.

If the keg is significantly taller than the. How to tap a keg. If you are paranoid you can give the keg a shot of co2 before filling it leaving it open co2 is heavier than air so it will sit in the bottom of the keg and push the air out. Pop into a keg straight from the store and youll just find sudsy warm beer inside.

This can either be at a bar or setup behind a wall. Remove any plastic or cardboard from around the tap fixture at the top of the keg. Fill the bottom of the bag with ice. Lay out the beer lines and co2 canister.

Beer needs to be kept refrigerated so you will need. Plan the space for your tap. The canister itself doesnt have to sit inside the refrigerator. Open the tap and pour yourself a cold one adjusting pressure as needed.