How To Make A Decorative Bow With Wired Ribbon

Soon your gift will be the talk of the party and no one will ever want to open it it will be.

How to make a decorative bow with wired ribbon. Place it on the table and start folding over 5 pieces on top of each other accordion style. This tutorial will show you how to make a beautifully large holiday bow using wired ribbon so that it doesnt wilt. This will create a third loop hanging in the bottom center. The size of the circle with roughly be the size of your finished bow.

To make a bow with wired ribbon start by cutting a length of ribbon to the size you want your bow to be. Bows are so beautiful. Take your pipe cleaner or wire piece and wrap very tightly around the center of the loops. Tie a length of ribbon around the wire or pipe cleaner to conceal it in the bow.

Begin with your wide ribbon. Remove the ribbon from the spool then start looping the ribbon around to create a circle. The bigger the bow however the more likely it is to flop and not look as beautiful as it should. Clip sides of the ribbon.

Then cross the loops over and under each other and gently tug on them to tighten the knot. Cross the left loop over the right loop. The more times youre able to loop the ribbon around the fuller your bow will end up so opt for at least three full circles. Tie thin ribbon around the.

Next make a loop on each side of the center of the ribbon and make sure the loops are pointing upward. Make two loops holding one in each hand with the tails draped over your fingers and facing away from you. Folding the ribbon instead of twisting it is the key.