How To Change A Door Lock Cylinder

Dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to the color code on the special instruction sheet.

How to change a door lock cylinder. Unscrew the main screw red dot place the key inside the cylinder and turn it to the left or right to make sure that the carrier is parallel with the cylinder. Remove the old cylinder from your door. We hope this has helped you out. Weve replaced door lock actuator we got the door panel back on and the screws all done.

With a barrel lock its the cylinder that allows the locking and unlocking of a door. Requires basic tools the drill then you can do it. Remove the lock front or faceplate by removing the two faceplate screws as shown above right loosen but do not remove the cylinder set screw next picture down turn the mortise cylinder counter clockwise until it comes out. Push the cylinder out of the lock maybe you need to push hard.

Insert another flathead screwdriver under the edges of the tabs holding the lock cylinder in place within the housing. Use a phillips head screwdriver to turn the set screw counterclockwise until you loosen it. Then insert the key into the lock and turn it about 10 degrees to line up the inner latch of the lock with the body of the lock. Door lock actuator replacement on these gm trucks and suvs its a pretty pretty easy installation.

Replacing a euro cylinder or upvc door lock a simple guide from wwwfastkeyscouk additional info step 1. The one presented here is a european barrel lock. Open front door to reveal the face of the lock. Insert a flatheaded screwdriver into the spindle housing hole.

There are several types of cylinder locks. Piece together the new door lock cylinder like the old one by putting the rubber gasket on the part of the cylinder that fit on the outside of the car door. Push the new small bracket onto the cylinder to hold the gasket in place. Locate the cylinder retaining.

To change a upvc door lock start by unscrewing the retaining screw which is located on the faceplate on the side of the door. Loosening the set screw will allow you to rotate the lock cylinder. Insert the pins and reassemble the lock. To remove the mortise cylinder from a mortise lock.

Loosen the set screw near the lock itself. The set screw will be the screw closest to the lock cylinder on the outside of the door.