How To Build Closet Shelves Clothes Rods

Part 2 will show the installation of upright walls under the top shelves which support hanging rods and clothes shelves.

How to build closet shelves clothes rods. Cut the plywood pieces according to the illustration. Repeat the process on the other side of the closet for the u shaped bracket. Thank you to our talented intern aj emmanuel for filming and editing this video. Spread wood glue on the joints then nail them together with 8d finish nails.

To put up structural support measure the depth of the side walls of the closet. From the back wall. How to make storage shelves. First nail through the sides into the back.

All you need is a 4 x 4 ft. Join housing kitsaps site supervisor mike as he explains how to easily install a closet shelf and hanging rod. This angled clothing rack is a great closet option when you are short on space and dont have a built in closet available. Simply cut another 1x2 board the length of your shelf minus 3 inches to accommodate the side supports and screw it to the studs along the back wall of the closet.

Cut two pieces of wood that are 1 by 5 inches 25 cm 127 cm to that depth. This chic clothing rack uses a different option as a shoe rack. To avoid having to harry houdini yourself around shelves install all your closet rod hardware before you put in the side shelves. Drill and attach wall brackets.

Attach the round bracket to the wall using a 2 wood screw. The hardware for the closet rods should be positioned about 1 12 to 2 in. Down from the shelf above and about 10 to 12 in. If you are building straightforward shelves you also need to add wood supports along the back wall of the closet.

Doesnt take long to make and you will be happy with the result. It is incredibly difficult to build. Laying out the closet clockwise end a section of clothes rod at the right end of the first wall then turning 90 degrees to the right measure 2 feet from the left wall of the next section and start with a partition. Pre drill a hole for the bracket screw using a 14 drill bit.

Plywood wood glue and a handful of 8d finish nails. Instead of the standard shelf or wire basket this one uses. Finish the closet rod and shelf system. This leaves the right amount of room for clothes on the first wall to hang without interference.

Inorder to build a closet shelf and rod you must first make shure you have the apopriate tools in order to do so.